Hydrous ferric oxide: evaluation of Cd-HFO surface complexation models combining Cd(K) EXAFS data,potentiometric titration results,and surface site structures identified from mineralogical knowledge

The surface properties of ferrihydrite were studied by combining wet chemical data, Cd(K) EXAFS data, and a surface structure and protonation model of the ferrihydrite surface. Acid-base titration experiments and Cd(II)-ferrihydrite sorption experiments were performed within 3<-log[H(+)]<10.5 and 0.5<[Cd(t)]<12 mM in 0.3 M NaClO(4) at 25 degrees C, where [Cd(t)] refers to total Cd concentration. Measurements at -5.5triple bond Fe-OH(-1/2),logk((int))=-8.29, assuming the existence of a unique intrinsic microscopic constant, logk((int)), and consequently the existence of a single significant type of acid-base reactive functional groups. The surface structure model indicates that these groups are terminal water groups. The Cd(II) data were modeled assuming the existence of a single reactive site. The model fits the data set at low Cd(II) concentration and up to 50% surface coverage. At high coverage more Cd(II) ions than predicted are adsorbed, which is indicative of the existence of a second type of site of lower affinity. This agrees with the surface structure and protonation model developed, which indicates comparable concentrations of high- and low-affinity sites. The model further shows that for each class of low- and high-affinity sites there exists a variety of corresponding Cd surface complex structure, depending on the model crystal faces on which the complexes develop. Generally, high-affinity surface structures have surface coordinations of 3 and 4, as compared to 1 and 2 for low-affinity surface structures.     

Analysis of the effects of catalytic bleaching on cotton

Hydrogen peroxide can be catalyzed to bleach cotton fibers at temperatures as low as 30°C by incorporating dinuclear tri-μ-oxo bridged manganese(IV) complex of the ligand 1,4,7-trimethyl-1,4,7-triazacyclononane (MnTACN) as the catalyst in the bleaching solution. The catalytic system was found to be more selective under the conditions applied than the non-catalytic H₂O₂ system, showing better bleaching performance while causing slightly lower decrease in degree of polymerization (DP) of cellulose. In order to gain fundamental knowledge of the bleach effect on cotton fibers and cellulose as its main component, especially after catalytic bleaching, X-ray Photoelectron Spectroscopy (XPS) was used to study surface chemical effects. The Washburn method was applied to investigate wetting properties, and liquid porosity was used to obtain pore volume distribution (PVD) plots. Parallel analyzes performed on model cotton fabric, i.e. “clean” cotton fabric stained with morin - a pigment regularly found in native cotton fiber, helped to differentiate between pigment oxidation and other bleaching effects produced on the (regular) industrially scoured cotton fabric. Bleaching was not limited to the chemical action but also affected cotton fiber capillary parameters most likely due to the removal of non-cellulosic materials as well as chain-shortened cellulose.     

Density and Volume Properties of the 2-Chloroethanol + 2-Methoxyethanol + 1,2-Dimethoxyethane Ternary Solvent System at Different Temperatures

The density of the 2-chloroethanol (CE) + 2-methoxyethanol (ME) + 1,2-dimethoxye- thane (DME) ternary mixtures has been measured at different temperatures ranging from –10 to 80^°C, and over the entire composition range. The experimental data have been used to check the validity of some relationships accounting for the dependence of the density on temperature and composition domains. Starting from the primary data, some derived quantities, such as excess molar volumes V ^E, partial molar volumes and partial excess molar volumes , have been obtained. In these mixtures, V ^E is always positive for the [CE(1) + ME(2)] binaries, while it is generally negative at all other experimental conditions, showing the greatest deviations along the binary axes corresponding to the binary subsystems in the sequence [CE(1) + DME(2)] < [CE(1) + ME(2)] < [ME(1) + DME(2)]. The results are compared and discussed to in terms of changes in molecular association and structural effects in these solvent systems.     

Influence of CaCO<Subscript>3</Subscript> nanoparticles shape on thermal and crystallization behavior of isotactic polypropylene based nanocomposites

Summary The influence of calcium carbonate nanoparticles with different shapes (spherical and elongated) on the thermal properties and crystallization behavior of isotactic polypropylene was investigated. CaCO₃ nanoparticles were covered by an appropriate coating agent to improve the interfacial adhesion between the filler and the polyolefin matrix. The nanocomposites were prepared by melt mixing and subsequent compression molding. A remarkable effect of CaCO₃ on the thermal properties of iPP was observed. Moreover, the analysis of crystallization kinetics showed that CaCO₃ nanopowder coated with PP-MA are efficient nucleating agents for iPP, and the overall crystallization rate results higher than plain iPP.     

The relative permittivity of 1,2-ethanediol+2-methoxyethanol+water ternary mixtures

The relative permittivities for the ternary 1,2-ethanediol (component 1) + 2-methoxyethanol (2) + water (3) solvent system have been measured for 66 mixtures covering the whole mole fraction composition 0X₁/X₂/X₃ 1 range at –10, –5 and 0 °C. The experimental data were used to test some empirical relations stating the dependence of = (X₁, X₂, X₃). A comparison between the calculated and experimental data show that these equations can be usefully employed to predict values in correspondence of the experimental data gaps.     

High temperature structures and orientational disorder in compressed solid nitrogen

An experimental study of the phase transitions at high temperature in compressed solid nitrogen has been performed using Raman spectroscopy. Knowledge of the equilibrium phase diagram in the region of the ordered epsilon phase and the two disordered delta and deltaloc phases, at pressures between 10 and 20 GPa, has been extended up to 500 K. The Raman scattering line shape and line width of the active vibrons has been measured accurately, along isobaric scans, across the phase transitions. Analysis of the width and of its different behavior with increasing temperature in the three phases led to more precise conclusions about the nature of the disorder in the different phases. Observation of an evident shoulder in the nu2 band of the deltaloc phase suggests the possibility that sites of two different symmetries may be occupied by the disk molecules in this structure.     

Extension of the Coulomb–Hole–Hartree–Fock theory to molecules

The Coulomb–Hole–Hartree–Fock method introduced by E. Clementi in the early 1960s and reparametrized more recently by S. Chakraworty and E. Clementi to compute the correlated electronic energy in atomic systems, is here extended to compute molecules. The new parametrization is obtained empirically by fitting first and second atomic ionization potentials from He to Ca and a few diatomic molecules. The present formulation makes use of either one or more determinants in order to ensure proper dissociation products, following the early proposal of G.C. Lie and E. Clementi in the context of density functional computations for molecular systems. The new formulation is tested against the dissociation energies of a large number of molecules and it is found satisfactory. © 1995 John Wiley & Sons, Inc.     

Analysis of the Temperature and Composition Dependence of Viscosimetric Properties of 2-Butanone <Emphasis Type="Bold">+</Emphasis> 2-Butanol Solvent Mixtures

Kinematic viscosities were measured for 2-butanone + 2-butanol binary liquid mixtures with a capillary Ubbelohde routine viscometer in the temperature range from 273.15 to 353.15 K at atmospheric pressure, and covering the whole miscibility field (0x_i1). Experimental data have been correlated by means of different empirical or semiempirical relationships, such as =(T), =(x_i), and =(T, x_i). Viscosity deviations, , from ideal behavior are negative at all experimental conditions, confirming that structure breaking effects prevail in the liquids. Furthermore, the thermodynamics of viscous flow and excess Gibbs energy of activation of viscous flow, G*^E, have been calculated. As an alternative and complementary approach to such investigations, the fluidity () of this binary system has been analyzed by the modified—Batschinski theory. The results are discussed in terms of the specific molecular interactions between the mixture components.     

First observation of the hyperfine structure of an excited quintet state in liquid solution

After pulsed photoexcitation of a new fullerene-linked bisnitroxide, a well resolved transient EPR spectrum is detected which is assigned to an excited quintet spin state generated by spin coupling of the nitroxides and the fullerene excited triplet.     

Gadolinium‐Decorated Silica Microspheres as Redox‐Responsive MRI Probes for Applications in Cell Therapy Follow‐Up

The redox microenvironment within a cell graft can be considered as an indicator to assess whether the graft is metabolically active or hypoxic. We present a redox‐responsive MRI probe based on porous silica microparticles whose surface has been decorated with a Gd‐chelate through a disulphide bridge. Such microparticles are designed to be interspersed with therapeutic cells within a biocompatible hydrogel. The onset of reducing conditions within the hydrogel is paralleled by an increased clearance of Gd, that can be detected by MRI.